Friday, November 25, 2011

Trenbolone – How to make your own Transdermal delivery system


A transdermal is made quite easily. Option number one is simply to get your hands on some DMSO, mix up a 50/50 mix of DMSO and water, add in the crushed up fina pellets and apply to the skin. The second is to make an alcohol carrier. You can find the necessary products at any local pharmacy and the more you buy, the cheaper it gets. All of it perfectly legal, easy to obtain since pharmacies are supplied 5 times a day and not too expensive. You need ethanol (as pure as it gets, I use SD40) and Isopropyl Myristate (IPM), a mix of isopropyl alcohol and myristic acid. Mix up 70% ethanol and 30% IPM and dissolve 50 mg per ml trenbolone in your solution. Meaning if you had a solution of half a liter (500 ml) you could add in 25 grams of trenbolone. Again, simply apply and let it dry. These methods will give you roughly 25% absorption of trenbolone.
To get the maximum it is recommended that you inject the stuff of course, but that’s slightly more complex as you need to get rid of a lot of the crap they put in these cartridges. You will need sterile oil, solvent (lipophillic), 1 empty sterile container, A syringe filter, two syringes and 2 18gauge needles. Start by putting your pellets in your solvent, and let it sit. You want the pellets to become completely undone and dissolved in your fluid. This is imperative. Shake it up real good and then let it sit for 12-48 hours to let all the crap sink to the bottom. Now take one of your syringes and start transferring the fluid into the sterile oil. You can decant as well, but you really don’t want any of the crud on the bottom to make it into this solution, so using the syringe and doing it slowly is the best way. Now take your empty sterile container and use a new syringe to transfer the oil. Attach a syringe filter between syringe and needle and slowly put the oil into your container, slowly filtering it. For everytime you repeat this step you need uncouple the filter/needle from the syringe, or else dirt will gather at the wrong side of the filter and get into your solution. In fact, if your container is a vial its advised that you leave the needle in the vial with the filter on it and you just use the syringe to refill and filter. This solution is now fit to be injected. Its still advised to hold the syringe with the trenbolone under some hot streaming water before injecting first though.



Nasal sprays and sublingual forms are also popular, and while they too have some minor success, they are the worst way to go. It’s a steroid, and with the added ester its even more lipophillic. Since the mucous membranes in the mouth and nose only let hydrophilic substances through, the rate of absorption is extremely limited. Usually to achieve this cyclodextrins are used, sugars that are lipophillic on the inside and can hold a steroid inside, but are hydrophilic on the outside, making the whole absorbable through these channels. But since fina does not have this and most of us do not possess the skills to make cyclodextrin complexes in our own kitchens, this is not a path one should consider.




No comments:

Post a Comment